Application Timing
Crops: 2-5 leaves
Weeds: Apply to actively growing weeds. Only weeds that are emerged at the time of application will be affected. Foliage that is wet at the time of application may decrease control.
Application Rates
Low rate: 245.8 mL/ac (80 acres/case or 320 acres/drum)
High rate: 371.4 mL/ac (53 acres/case or 212 acres/drum)
Directions for Use
- Spray when weeds are at the 2-5 leaf stage.
Tank-mixing Instructions- Clean spray tank and half fill with clean water. Start agitation or bypass system.
- Add correct amount of Pulsar herbicide, graminicide if being used and then add the correct amount of MCPA Ester (500 series) if being used and continue to agitate.
- Agitate for 2-3 minutes.
- After any break in spraying operations, agitate thoroughly before spraying again.
- Use the spray suspension as soon as it is prepared.
- Follow directions and precautions as outlined above, especially when applying next to sensitive crops (e.g., forages, legumes and canola).
- Follow sprayer clean-up directions.
Ground Application
Water volume: 110 L water/ha
Spray nozzles: 80° or 110° flat fan nozzles are recommended for optimal spray coverage. Use 50 mesh nozzle screens. Do not use flood type nozzles, controlled droplet applications equipment, spray foils or hollow cone nozzles.
Pressure: 275-310 kPa
Apply uniformly at 6-8 km/h and avoid overlapping. Shut off spray boom while starting, turning, slowing or stopping to prevent crop injury from an over application.
Please note, Pulsar is not registered for aerial application.
Restrictions
Do not harvest the treated crop within 60 days after application.
Do not graze cattle on treated crop, or harvest for silage until 7 days following the application of Pulsar herbicide alone and at least 12 weeks following treatment with Pulsar herbicide tank mixes.
Withdraw meat animals from treated fields at least 3 days before slaughter.