Scab: 560-836 mL/ha (227-338 mL/ac)
Protective spray schedule:
Apply every 7-10 days starting at ¼- ½ inch green tip or when environmental conditions become conducive for scab. Continue through petal fall until the threat of primary scab is passed.
Forecasting spray schedule:
Use a forecasting system beginning at green tip. Apply within 48 hours of the onset of an infection period; apply a second spray after 7 days.
Brooks fruit spot, cedar apple rust, flyspeck, quince rust, sooty blotch: 836 mL/ha (338 mL/ac)
Begin applications preventively. Apply on a 7-10 day schedule through the second cover spray.
Powdery mildew*: 836 mL/ha (338 mL/ac)
Begin applications at the tight cluster stage and continue on a 7-10 day schedule. *Suppression
Foliar anthracnose: 836-1161 mL/ha (338-470 mL/ac)
Alternaria rot: 836-1475 mL/ha (338-597 mL/ac)
Powdery mildew: 836 mL/ha (338 mL/ac)
Botrytis bunch rot: 1033-1475 mL/ha (418-597 mL/ac)
Black rot: 1475 mL/ha (597 mL/ac)
For best results, sufficient water volume must be used to provide thorough coverage. A minimum of 375 L/ha (37 gal/acre) for ground applications is recommended.
To improve scab control Inspire Super must be tank-mixed with a protectant fungicide such as Allegro®.
When scab is present in the orchard, do not make more than 4 applications of Inspire Super or any other Group 3 or Group 9 fungicide.
For foliar anthracnose, Alternaria rot, Botrytis bunch rot and black rot, begin applications prior to disease onset when conditions are conducive for disease. Apply on a 15- to 21-day schedule. If disease pressure is high, use the shortest interval and, where applicable, the highest rate.
For powdery mildew, begin applications at bud break and apply on a 15- to 21-day interval.
WALES Symbol: E
Add ½-¾ of the required amount of water to the spray or mixing tank.
With the agitator running, add the tank-mix partner(s) into the tank, if using. Add wettable powders and water dispersible granular products first, then liquid flowables, and emulsifiable concentrates last.
Allow the material to completely dissolve and disperse into the mix water. Continue agitation while adding the remainder of the water and Inspire Super to the spray tank.
Allow Inspire Super to completely disperse.
Spray the mixture with the agitator running.
Observe all directions for use, crops/sites, use rates, dilution ratios, precautions, and limitations which appear on the tank mix product label.
Label dosage rate must not be exceeded, and the most restrictive label precautions and limitations must be followed.
This product must not be mixed with any product which prohibits such mixing.
Do not make more than two consecutive applications of Inspire Super or other products from the same group of chemistry before alternating to another fungicide with a different mode of action.
Do not apply Inspire Super Fungicide within 14 days of harvest (14 day PHI).
Restricted Entry Interval (REI): 12 hours.
Two hours. Avoid when rain is forecast.